Notifications
Clear all
MMU3 infill
I have a large print and I don’t have enough filament to do it, and I only have one roll. Is it possible to use the mmu to have a different color for the infill or supports?
Posted : 31/10/2024 4:14 am
RE:
Yes, but it will probably not solve your problem, because it will add a lot of material to the wipe tower (even with wipe to infill enabled)
This post was modified 11 months ago by Robin
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
Posted : 04/11/2024 3:32 pm