Notifications
Clear all

Mk3s+ PETG warping / large-ish print  

Strona 2 / 2
  RSS
ssill2
(@ssill2)
Noble Member
RE: Mk3s+ PETG warping / large-ish print

@popepanator

Waiting with bated breath!   I'll definitely be trying that next time I print something that large.

Opublikowany : 06/06/2021 10:06 pm
JackCC polubić
JackCC
(@jackcc)
Active Member
Topic starter answered:
RE: Mk3s+ PETG warping / large-ish print

Okie dokie, so, 

I woke to find it had completed successfully! No measurable warping had occurred, though when it took the part off the sheet, I noticed that there must of been some serious force. To the extent that it started to de-laminate the PEI sheet 😐

might have to order a new one later as it has produced noticeable lumps where the four corner were.

Opublikowany : 07/06/2021 11:17 pm
ssill2
(@ssill2)
Noble Member
RE: Mk3s+ PETG warping / large-ish print

I find those go away.  I've seen them before too, but they tend to disappear, at least for me.

Opublikowany : 07/06/2021 11:20 pm
bobstro i JackCC polubić
ssill2
(@ssill2)
Noble Member
RE: Mk3s+ PETG warping / large-ish print

and that's a nice looking part.  Good job

Opublikowany : 07/06/2021 11:21 pm
JackCC polubić
JackCC
(@jackcc)
Active Member
Topic starter answered:
RE: Mk3s+ PETG warping / large-ish print

Thanks again everyone, for your kindness and assistance. ❤️ 

Opublikowany : 08/06/2021 1:45 am
ssill2
(@ssill2)
Noble Member
RE: Mk3s+ PETG warping / large-ish print

@popepanator

Sure. Good luck!

Opublikowany : 08/06/2021 1:47 am
JackCC polubić
Strona 2 / 2
Share: