Avisos
Vaciar todo
Infill modifier - based on height
Hello,
I am printing a fire token for board game, the base - I want to fill it with standard infill 20%, but at 2mm height there will be fire with diferent filament, so filament will be changed to transparent and I want to setup 0% infill and 1 or 2 perimeters.
Any chance to do it in prusaslicer? (have 2.2.0)
Respondido : 03/11/2020 1:22 pm
RE: Infill modifier - based on height
Yeah just use either a height range modifier or a normal modifier. Height range would probably be easier though.
https://help.prusa3d.com/en/article/modifiers_1767 Is the knowledge base article on the modifiers.
Respondido : 03/11/2020 4:46 pm