Huge print : Hollowing / Nozzle size ?
Hi Guys,
After having printed successfully a middle sized T Rex (in 8 pieces, about 50 cm high / 30 cm wide and 80 cm long), I'd like to print a bigger version.
1) As to save on filament but stay safe with overall rigidity, I would need to keep infill in a few centimeter perimeter (thus creating an inner wall).
I think I've seen the hollowing feature for SLA but how to proceed with my MK3s ??
2) I have never printed with another nozzle than the 1,75, I guess this project would benefit from a 2,85 and a rougher definition ??
Thanks in advance for your thoughts.
Stay safe / Mike
RE: Huge print : Hollowing / Nozzle size ?
Things to consider:
- Use adaptive support infill with a higher infill density. It makes a huge difference on density, using very little at low layers, but dense (I like 25-40%) to support top layers and get a good finish. I've got some notes here and here that might be useful.
- Use wider perimeter extrusion widths for rigidity and strength. You can go up to 200% of nozzle size with good nozzles. Notes here.
- A 2.85mm conversion won't help anything. Older printers used 3mm because that's what filament size was available at the time. 1.75mm melts much faster and evenly. If you need more volumetric throughput, I have notes here. You need to increase your volumetric rate. Hotend mods or replacement can help (e.g., Volcano hotend) or just the right nozzles (e.g., 3D Solex). Notes here.
and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan
RE: Huge print : Hollowing / Nozzle size ?
Hi Bobstro,
thanks for having looked at my issue and for the comprehensive answer ; I've load to read and consider but I'll keep you posted.
Stay safe / Mike