holes and it is not due to retract
Hello dears, I am printing this piece and I have these holes, apparently they are formed because plastic is gathered in the beak that eventually falls on a perimeter, can I improve it by adjusting my k factor?
![](https://forum.prusa3d.com/wp-content/uploads/2022/03/WhatsApp-Image-2022-03-16-at-3.37.08-PM-600x500.jpeg)
![](https://forum.prusa3d.com/wp-content/uploads/2022/03/WhatsApp-Image-2022-03-16-at-3.37.08-PM-1-600x500.jpeg)
Log in to be able to post
Posted : 16/03/2022 6:42 pm