Avisos
Vaciar todo
Help refining my prints on a New Build
I think my first layer is just about sorted, but things are not quite right, I'd appreciate any suggestions on what the issue might be. I've attached a few photos.
Respondido : 08/04/2020 4:47 pm
Topic starter
answered:
RE: Help refining my prints on a New Build
The two half of the starpug turned out quite well.
Respondido : 08/04/2020 4:47 pm
Topic starter
answered:
RE: Help refining my prints on a New Build
Last image, is this the issue? (all suggestions welcome)
Respondido : 08/04/2020 4:53 pm
Topic starter
answered:
RE: Help refining my prints on a New Build
A new FLC with a slightly higher Z.
Respondido : 08/04/2020 5:44 pm