Notifications
Clear all

[Solved] Help printing RPi case lid  

  RSS
cbcurran
(@cbcurran)
Active Member
Help printing RPi case lid

Hi - Im trying to print the lid for this RPi 3 case. 

https://www.prusaprinters.org/prints/4516-raspberry-pi-3-case-for-pi-buck-converter-direct-p

I tried to print this lying flat and got some bad sections on one end.  After trying again, I received crash detection errors.

I tried to print upright and there wasn't enough support to keep it stable.

Im assuming that printing a lid like this should be done lying flat on the bed and I need to resolve the bad print/crash issues?  Any thoughts?  Printer has been working great for other prints and I checked the belt settings and all seem ok there. 

Best Answer by JoanTabb:

I would try to print this model as below

Regards Joan

Posted : 29/09/2019 7:49 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Help printing RPi case lid

I would try to print this model as below

Regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 29/09/2019 8:42 pm
cbcurran
(@cbcurran)
Active Member
Topic starter answered:
RE: Help printing RPi case lid

Thanks.  Trying again as you suggest. Thanks!

Posted : 29/09/2019 8:45 pm
Share: