Fuzzy layers when printing calibration cube

Ultimi post

RSS

Robinf

(@robinf)

New Member

Fuzzy layers when printing calibration cube

When printing the calibration cube, I get a weird mix of fuzzy layers in between. I'm using eSUN PETG printing using the Generic PETG profile with only the following changes:

Lift Z: 0
Retraction speed: 35 mm/s

Does anyone have any idea why this is happening?

Postato : 12/01/2022 12:01 pm

Statistiche Forum

559 Forum

62.9 K Discussioni

442.9 K Post

19 Online

67.7 K Utenti

Post recenti: Trouble with support structure Ultimo utente registrato: pinklemonade Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso