First Calibration and print
Please see photos. First layer for Prusa logo went really bad. I cleaned sheet and Z is at 0.738 and recalibrated first layer. How can I improve?
Thanks!
RE: First Calibration and print
@wayne-p
Your way to high, Lower the Live Z until you get a good squish.
Regards
Swiss_Cheese
The Filament Whisperer
RE: First Calibration and print
@wayne-p
Your way to high, Lower the Live Z until you get a good squish.
Regards
Swiss_Cheese
I am at 0.738. Should I move knob to left to increase the -ve number? To something like 0.800? I tried another Prusa logo and looked somewhat better but nozzle got gummed and took part off the sheet. Thoughts?
RE: First Calibration and print
Go down in steps of -0.1 until you get good adhesion, then finetune in steps of -0.02 or less to optimize it.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...