eSun PETG Profile in Prusa Slic3r

Dernier message

RSS

daniel.d30

(@daniel-d30)

Eminent Member

eSun PETG Profile in Prusa Slic3r

Hello everyone,

I'm tinkering with my PETG profile due to stringing and I was wondering if anyone has an eSun PETG profile floating around for Prusa Slic3r that they are proud of? Care to share it or give a link?

Thanks

Publié : 16/04/2018 12:20 am

Seth

(@seth-5)

New Member

Re: eSun PETG Profile in Prusa Slic3r

I haven't gotten all of the kinks out, but stringing has been reduced dramatically from default generic PETG with the attached settings. Primary tweaks are to temperature, retraction, and speed.

Any further improvements you can make on these settings would be appreciated (or, if you've already improved on these, please share).

Publié : 17/04/2018 2:54 am

daniel.d30

(@daniel-d30)

Eminent Member

Topic starter answered:

Re: eSun PETG Profile in Prusa Slic3r

Thank you!

Publié : 18/04/2018 3:34 pm

Statistiques du forum

559 Forums

63 K Sujets

443.2 K Messages

21 En-ligne

67.8 K Membres

Le dernier des messages: Snug support failing almost every time Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé