Notifications
Clear all

esun 95A TPU with 0.6mm nozzle, unsatisfactory results  

  RSS
PRINTERPAUL
(@printerpaul)
Active Member
esun 95A TPU with 0.6mm nozzle, unsatisfactory results

I used slicer setting for ultra fuse 95A TPU loaded into prusaslicer, I couldn't find esun TPU or generic TPU slicer settings.

I experienced a jam on my next TPU print after this bench shaped object.

I'm using a 0.6mm Nozzle X nozzle.

My guess is to change the speed to all 20 mm/s?

Publié : 26/08/2023 9:52 am
Partager :