compression spring

Dernier message

RSS

FG's

(@fgs)

Active Member

compression spring

Has anyone printed a compression spring? if so, any recommended angle for setup?

Thanks,

Publié : 26/03/2020 2:01 am

davidhajjar a aimé

davidhajjar

(@davidhajjar)

Active Member

RE: compression spring

I have the same question. Maybe PLA will not be flexible for the funcionality, but I want to print it to check if space/building fits good (I still haven't got the metal spring)

Publié : 04/05/2020 5:21 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.2 K Messages

22 En-ligne

68.1 K Membres

Le dernier des messages: Prusa Connect fails to upload to the MK4 - some file not all Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé