Notifications
Clear all
Page 2 / 2
Prev
RE: Blob after failed PETG print
You can always use extra parts. It is often better to save them and start fresh.
--------------------
Chuck H
3D Printer Review Blog
Posted : 19/05/2021 1:27 am
Topic starter
answered:
RE: Blob after failed PETG print
Wanted to give an update on this problem/solution. Prusa support replaced hotend assembly that came with the original kit. I installed it, recalibrated everything, and it's been printing great for several hundred hours. It seems that the new assembly came properly tightened. No more blobs forming. Thanks everyone for the suggestions, I still learned a lot from the tips that came in!
Posted : 05/07/2021 1:50 pm
Swiss_Cheese liked
RE: Blob after failed PETG print
@surfman49
That's good news,
Thanks for following up.
Swiss_Cheese
The Filament Whisperer
Posted : 06/07/2021 8:02 pm
Page 2 / 2
Prev