Notifications
Clear all
Z levelling enforced
Hi
For several months now have been getting a consistent a levelling enforced error at the beginning of prints during mesh bed levelling. Always at the first point and everytime.
This has happened with an old and new super pinda (both tested and working). I've also checked the height of the pinda and readjusted many times.
I've done a factory reset a few times and full xyz and z calibration many dozens of times.
From what I can see the axis are all homing fine and the trapezoidal nuts are center and turning ok.
Prusa support has been unable to help. Does anyone have any idea what it could be or what I can do next besides throwing the printer away any buying a new one?
Thanks for any help.
Publié : 21/05/2022 11:57 am