Notifications
Clear all

Z axis stepper stays active after printjob  

  RSS
ArkoXS
(@arkoxs)
Active Member
Z axis stepper stays active after printjob

Hi there,

I've noticed that my printer keeps the z-axis steppers active after it finishes the print. It makes a soft buzzing sound (at first I thought the fan was spinning), and both the steppers stay warm, even hours after the print has finished.

Does this sound familiar to anyone? I have no idea where to start troubleshooting. Thanks in advance.

I have a Prusa i3 MK3S with the 3.11 (0-4955) firmware. Printing is not an issue, it just starting to irritate.

Regards,

Publié : 19/09/2022 10:21 am
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Z axis stepper stays active after printjob

The X axis is purposefully kept energised whilst the printer is energisd. it is design intent. Regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Publié : 19/09/2022 2:24 pm
Partager :