Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
Hello friends of the molten plastic,
for some time now i have had problems with my printer that i can't solve. During printing, the printer stops, the Z-axis moves up a few millimetres and then starts to feed filament like crazy. After one or two seconds the print head moves down again and continues printing. This behaviour leads to very unsightly filament bumps on and around my prints.
Does anyone have an idea what this is due to?
Unfortunately I cannot upload a video because it is blocked by the forum.
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
good morning Tobias.
one of the limited file types, is ZIP...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
@joantabb
I tried to upload a youtube link.
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
Save the project as a .3MF file, save it in a ZIP file, and upload the zip. Far easier to look at what you did in the slice than decipher something from a video.
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
Here is my GCODE and the Project.
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
ZIP the files and attach to the forum; third party websites can't be trusted. Just too many hacks and trojans.
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
OK, just uploaded the file to the Forum:
Thank You for helping! 🙂
RE: Z-Axis moves UP and Down while Printing and Extrudes Pushes Filament
This problem occurs more at this Project!