Benachrichtigungen
Alles löschen
Z axis grinding during filament change
Hello All, First time poster here!
Relatively new to 3D printing, only couple months in.
When printing in multiple filaments i get the following issue (mk3s, slicer 3.70, Firmware3.13.2-7080, silent mode enabled)
During the change i do all the steps. But the extruder then grinds (and making grinding noise) when it goes up the Z axis like it's not moving correctly, this then misplaces the nozzle for extruding causing it to jab into the print and ruining it. Just had a 5 hour out print ruined because of this.
Anyone know what's going on?
Veröffentlicht : 05/12/2023 4:53 pm