Notifications
Clear all
Z-Axis Crash issue
Hey all, thanks ahead.
Please see attached video which will explain the problem. Note I did run a print that failed the previous day, I cleaned up the PLA, but something must have gotten broken or out of adjustment...
I have tried a full reset/wizard, but it fails on the Z axis when trying to do the first layer calibration via the wizard due to a crash, z-axis issue.
Maybe there are common starting points for me to troubleshoot this?
Posted : 06/01/2021 7:03 pm
Topic starter
answered:
RE: Z-Axis Crash issue
Bumping, trying to find a solution, it continues to do this sometimes but not all the time, in the video you can see where it drags and seems to have extreme resistance.
Posted : 12/01/2021 2:00 am
Topic starter
answered:
RE: Z-Axis Crash issue
Here is another video, shorter, am I the only person who has had this issue?
Posted : 12/01/2021 2:20 am