Y-Axis Issue
Hey everyone, I'm having an issue with my Mk3S that I can't figure out. I've been printing without any issues for some time now, even after changing out my belts. But when I went to check on a print, it appeared as though it had suffered a very sudden, major layer shift. Now I can't get the Y-axis to work properly and it keeps giving me a Y-axis length error during any action. Whenever it moves, it goes as far back as it can then keeps trying to go back further. And then it'll also seem to struggle to move back up. Moving the carriage with my hand, I feel no snags and inspections haven't shown anything they might catch on. I recently changed the bearings, but the issues still persist. The printer is almost 3 years old now with a LOT of print hours on it, so I'm not sure if it's something else I need to replace or something simple I'm missing. Any ideas?