Notifications
Clear all
X-Axis Motor Spinning in Place
I recently had the x-axis stop working. Upon closer inspection, I noticed the rod is spinning in place on the motor.
Its been a couple of years now since I've built it, so I'm a big ignorant on how I might fix it and going through the manual didn't exactly help me figure it out. Hoping someone can review the video and give me some direction on how I could address this issue.
Thanks!
Best Answer by Jason:
I was able to figure this out. It seems the grub screw had come loose and so I tightened it. Once I did that, no problem.
Posted : 05/04/2020 4:05 am
Topic starter
answered:
RE: X-Axis Motor Spinning in Place
I was able to figure this out. It seems the grub screw had come loose and so I tightened it. Once I did that, no problem.
Posted : 05/04/2020 5:37 am