Notifications
Clear all
Voids or under-extrusion (at layer change?)
Greetings, I'm using a MK3S and there seems to be voids in many prints occur in particular places. These problems happen on the outside wall as well as in the infill. Could it be related to extrusion rate, filament retraction, or some form of extruder issue? What else am I doing wrong? (PETG Filament)
uneven edges
voiding?
infill issues
Opublikowany : 13/05/2024 12:38 am
Topic starter
answered:
RE: Voids or under-extrusion (at layer change?)
Prints were sliced with Cura
Opublikowany : 13/05/2024 7:23 pm