Benachrichtigungen
Alles löschen

vertical lines on y  

Seite 2 / 2
  RSS
Mike
 Mike
(@mike-8)
Estimable Member
Re: vertical lines on y

Is your belt properly aligned? For me it almost looks like the teeth of the belt are always scraping a bit on the wall of the idler. If that's it, then you should better straighten the belt and maybe apply some grease so the effect is not that strong.

Veröffentlicht : 23/10/2018 9:22 pm
Mark
 Mark
(@mark-11)
New Member
RE: vertical lines on y

Hello, did you ever figure out these vertical lines issue? My prints are doing the exact same thing. 

Posted by: @schichtenmacher

I need help....
i have vertical lines on my y axis and only on my y axis
left on the foto is y and right is x

 

 

what i allready have done:
- change belt ( stock and powrgrip gt3)
- change bearings (stock, cheap one and misumi)
- change printed parts
- Belt Status X 260 and Y 265
- test silent and normal mode

all make no different

just ordered new pulley, that the only thing i did not change

Slicer Prusa (latest) stock settings
Firmware latest

what could it be? because its only on the y axis

 

Veröffentlicht : 14/05/2022 1:52 pm
Mark
 Mark
(@mark-11)
New Member
RE: vertical lines on y

Hello, I'm having the exact same issue with my prints. I see vertical lines in my Y-axis side, however I also see them very slight in my X-axis. My belts are the correct tension, rods clean and lubricated. New nozzle, latest firmware, using dry PLA. It just seems too uniform to be a hardware issue, could it be a slicer issue? Or some other software issue I'm overlooking? Thanks

Veröffentlicht : 14/05/2022 1:55 pm
Seite 2 / 2
Teilen: