Notifications
Clear all
Upgraded to BallBearing Extruder Sensore with a Bowden tube connector. Cannot load filament.
Hello Everyone.
I have an MK3s+ and I upgraded the Sensor to the ballbearing setup and I modified it so I can use a bowden tube. I have an MMU2s and now when I go to load the filament it does not work. Has anyone else done something like this? The filament gets to the sensor and goes no further. I think once it sees the filament at the extruder the MMU2s stops pushing the filament maybe?
Thank You
Opublikowany : 11/04/2022 11:30 pm