Notifiche
Cancella tutti
TLC advice for my MK3S to improve layer lines?
Hi all,
My faithful old MK3S is starting to look a bit shabby next to my Bambu labs P1S - I know it's waaaay slower and not much I can do about that, but the print quality is standing out now - I'm pretty sure it's been better, so keen to understand what I can do to improve this.
Example below of prints - same filament comes out flawlessly on P1S - ie can't even see layer lines!
Any advice on best ways to improve this? The printer has been a workhorse, so suspect needs some TLC/maintenance, but not sure where to start on this.
Postato : 10/11/2023 5:33 am