Notifiche
Cancella tutti
Thermal Module Calibration aborted by itself
Hi, I installed the latest Firmware 3.12.2 on my i3MK3S+ with Revo 6 nozzle. The Thermal Module Calibration started and I read from the LCD that it would take over 10 minutes but after about 2 seconds, it aborted by itself. Tried three times already. What is wrong? Am I supposed to perform such calibration after installation of the firmware?
Questa discussione è stata modificata 2 years fa 2 tempo da prusanewuser
Postato : 27/04/2023 10:11 pm
RE: Thermal Module Calibration aborted by itself
The Revo 6 has issues and does not work with firmware 3.12.2. This is known issue that Prusa is working on. Rollback (flash) the firmware for now to 3.11 and you will be fine
Postato : 27/04/2023 10:53 pm
prusanewuser hanno apprezzato