Benachrichtigungen
Alles löschen
Thermal Calibration issues
Hello,
My MK3s+ was running Firmware 3.11 and I decided to upgrade to 3.13 today. After I updated the firmware, the machine started performing a "Thermal Calibration" It completed the thermal calibration, but I wasn't expecting it and am not sure I had it set up right for the calibration.
1) The spring steel bed sheet was on at the time. Based on what I have read, I believe that should have been off, but I also read that there would be a message asking if it was on or off which I never saw.
2) It was in its enclosure, but the door was open. Should the door have been closed?
3) There was PETG loaded in the hot end. Should the hot end have been loaded or unloaded?
Thanka!!!
Veröffentlicht : 18/02/2024 11:19 pm
Themenstarter answered:
RE: Thermal Calibration issues
Please delete - I accidentally made a redundant post
Veröffentlicht : 18/02/2024 11:25 pm