Notifications
Clear all

Sudden Y-axis Noise on new printer  

  RSS
djf730
(@djf730)
New Member
Sudden Y-axis Noise on new printer

I know post like these are very common, but I have a relatively new printer (only 20 prints or so) that I purchased pre-assembled that has recently begun getting very noisy while printing. The most notable sounds is a whining/griding sound that is prominent when the Y-axis is moving.
https://forum.prusa3d.com/wp-content/uploads/2022/04/Pxl-20220407-154546101.m4v

Is there anything I might have done wrong in maintenance? Reading the provided care documents, there didn't seem to be any maintenance needed so early in the printer's life, but I'm not sure where this sound would be coming from so soon. It started subtly a few prints ago but seems to only be getting louder.

Any advice appreciated! 🙂

This topic was modified 2 years ago by djf730
Posted : 21/04/2022 2:48 am
Share: