Notifications
Clear all

Stuck filament in extruder at filament pullout  

  RSS
DanielM
(@danielm)
Eminent Member
Stuck filament in extruder at filament pullout

Hi,

Since I installed the MMU2S I have issues with the filament retraction from the extruder. When the filament it is extracted it is stucked in the extruder as in the attached picture. 

This is happening quite often and it is not depending on the filament brand. Any suggestion is welcome. 

 

The orange piece is at the top of the extruder. 

Best regards,

Daniel

Napsal : 13/10/2021 2:43 pm
Share: