Čeština
Fóra
English forum
Original Prusa i3 MK3 & MK3S & MK3S+
Hardware, firmware and software help
Stringing, artifacts, and rough looking overhangs on prints after changing hotend
 
Notifications
Clear all

Stringing, artifacts, and rough looking overhangs on prints after changing hotend  

Stránka 2 / 2
    Poslední Příspěvek
  RSS
jayden17
 jayden17
(@jayden17)
Eminent Member
Topic starter answered:
RE: Stringing, artifacts, and rough looking overhangs on prints after changing hotend

Not probably the ideal solution but eventually (months later) I just bought yet another hotend (fully assembled version this time) and the issue seemed remedied.

Napsal : 12/10/2023 11:18 pm
Stránka 2 / 2
  All forum topics
  Previous Topic
Next Topic  
Share: