Avisos
Vaciar todo
Strange, Worrisome Noise on First TPU Print
I've been doing some simple prints using the PLA which came with the printer (MK3S). Just a few minutes ago I started my first print using the SainSmart TPU fiament. For a few minutes the printer sounded perfectly normal. But then it started to make a strange clicking sound.
(The beep at the end did not come from my laptop not from the printer.)
Until I hear otherwise I think I will not use the printer until I understand what is going one.
Thanks, Bob
USA / PA / 17821 : Fusion 360 > PrusaSlicer > Prusa MK3S
Respondido : 03/09/2020 8:16 pm