Notifications
Clear all

Strange, Worrisome Noise on First TPU Print  

  RSS
BobG
 BobG
(@bobg)
Eminent Member
Strange, Worrisome Noise on First TPU Print

I've been doing some simple prints using the PLA which came with the printer (MK3S).  Just a few minutes ago I started my first print using the SainSmart TPU fiament.  For a few minutes the printer sounded perfectly normal.  But then it started to make a strange clicking sound.  

(The beep at the end did not come from my laptop not from the printer.)

Until I hear otherwise I think I will not use the printer until I understand what is going one.

Thanks,  Bob

 

USA / PA / 17821 : Fusion 360 > PrusaSlicer > Prusa MK3S

Posted : 03/09/2020 8:16 pm
Share: