Notifications
Clear all

Slicr Problem  

  RSS
gatonini@zoominternet.net
(@gatoninizoominternet-net)
Eminent Member
Slicr Problem

Hi

Just installed my mk3s parts flashed my firmware and loaded the new slicr and software my problem is that I can no longer send gcode from slicr to my octoprint I know how to set slicr up to do this but now it errors out and wont send it to octoprint it tells me the connection is good when I test it but it would send my gcode any ideas

Opublikowany : 26/02/2019 8:09 pm
Share: