Slic3r PE - Change Filament - PETG

Dernier message

RSS

PCFrog

(@pcfrog)

Active Member

Slic3r PE - Change Filament - PETG

I'm con-fuddled at why when utilize PETG the printer stops after each layer and wants me to change the filament. I rechecked the settings in Slic3r to make sure it was not on multi colors or materials (those that I know to check). What am I missing?

Publié : 21/02/2019 6:14 pm

(@)

Illustrious Member

Re: Slic3r PE - Change Filament - PETG

Check the printer custom gcode for any remnant filament commands (especially if you have an mmu).

Also - try turning off the filament sensor from the lcd controls. The optical filament sensor has been known for doing odd things with some filaments.

ps: The laser based optical motion sensor "funniness" is why many of us are paying to 'upgrade' to the much less sophisticated IR sensor.

Publié : 21/02/2019 7:16 pm

PCFrog

(@pcfrog)

Active Member

Topic starter answered:

Re: Slic3r PE - Change Filament - PETG

Check the printer custom gcode for any remnant filament commands (especially if you have an mmu).

Also - try turning off the filament sensor from the lcd controls. The optical filament sensor has been known for doing odd things with some filaments.

Thanks, turning off the sensor worked.

Publié : 22/02/2019 4:37 am

Statistiques du forum

559 Forums

62 K Sujets

438.9 K Messages

16 En-ligne

67.2 K Membres

Le dernier des messages: Prusa Slicer 2.8.1 kein Anmelden an Prusa-Link im Netzwerk möglich Notre nouveau membre: Gajowy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé