Screen frozen on power on after hotend assembly change
Hi everyone, so I changed my hotend assembly (heating element + thermistor) and when I reassembled it I’m facing the following issue when power on.
The screen just freezes up and I can do anything. I’ve checked the wiring but can’t seem to find anything else wrong.
Anyone faced this issue before? Or any suggestions on where I could try troubleshooting?
RE:
My troubleshooting advice would be: unplug heater and thermistor from einsy, power up and see what happens. Measure resistance of unplugged heater and thermistor on the einsy side of the wiring.
See: https://help.prusa3d.com/en/article/multimeter-usage_2117
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!
RE: Screen frozen on power on after hotend assembly change
Turns out the board is fired, plugged it into a computer and no recognition unfortunately