Revo hotend "Thermal Anomaly" while running the Revo version of firmware on MK3S
So I upgraded my machine with the revo version of the firmware awhile back (shortly after it was released) but I am now getting thermal anomaly errors, sometimes it just beeps and keeps printing (beeping every so often) but sometimes it stops the print. I did the PID tune and all seemed OK and it was working fine until a few days ago.
I heated it up and wiggled the wires from the heater core all the way back to the electronics box (in case of a bad connection) but I saw no fluctuation of the temperature reading at all. I use Octoprint and except for tiny fluctuations (just super tiny ripples) I see no issues during printing either.
I am at a loss now. I need it working as I earn money with this machine.
Any ideas?
Firmware version 3.13.0-6873
RE: Revo hotend "Thermal Anomaly" while running the Revo version of firmware on MK3S
Has the ambient temperature in your workshop, changed recently?
It's become very cold, in the UK where I live.
this change in temperature may affect thermal performance...
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Revo hotend "Thermal Anomaly" while running the Revo version of firmware on MK3S
I live in Southern California USA and while it has gotten cooler it's not by much, it's normally around 25c here and now it's about 20c inside. I did just last night update to the latest Revo firmware 3.13.2 and did 1-2 hour print and it did not give me the error, not conclusive at only 2 hours but looking better. Fingers crossed.
RE: Revo hotend "Thermal Anomaly" while running the Revo version of firmware on MK3S
If the problem persists, I would downgrade the firmware to 3.11.x (without new thermal model).
Alternatively, you can try deactivating the thermomodel: M310 S0
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Revo hotend "Thermal Anomaly" while running the Revo version of firmware on MK3S
I was thinking of downgrading if I can't sort this out. Didn't know I could disable the thermo model though.