Avisos
Vaciar todo
PrusaLink on MK3S+ will not start
Hi folks,
I try to get PrusaLink to run on my MK3S+ with a Pi Zero W - maybe someone can share his/her experience?
Setup
- MK3S+
- FW 3.14.1
- Raspberry Pi Zero W 1.1
- PrusaLink 0.8.1
I followed this tutorial: https://help.prusa3d.com/guide/prusalink-and-prusa-connect-setup-mk3-s-_221744
- Beautiful soldered 19mm GPIO (see picture).
- Raspberry LED lights up (see picture).
- Raspberry is to see in my Wi-Fi list.
Problem
- The printer is stucked in this message --> "Starting PrusaLink"
- PrusaLink Wizard is stucked in this message -->"/dev/ttyAMA0: [RPi] NOT USABLE ... ✘"
Photos
Este debate ha sido modificado el hace 3 weeks 2 veces por Alec Sears
Respondido : 31/12/2024 2:56 pm
Topic starter
answered:
RE:
Turned out, the Raspberry Pi was the source of the problem.
- I bought a new Raspberry Pi Zero 2 W. It works like a charm! 😊
Respondido : 08/01/2025 6:02 pm