Notifications
Clear all
Prusa - LCD character jibberish?
During the wizard calibration process, this was displayed. The calibration went fine but curious what this is? Is there a fix?
MK3s / My IKEA Lack enclosure
Publié : 04/05/2019 4:56 pm
RE: Prusa - LCD character jibberish?
Check the routing and seating of the LCD cables. This may be caused by a loose connector or by interference from other cables.
Publié : 04/05/2019 5:39 pm
jurassic73 a aimé
Topic starter
answered:
RE: Prusa - LCD character jibberish?
This could be the issue. I do have OctoPrint set up:
MK3s / My IKEA Lack enclosure
Publié : 04/05/2019 9:19 pm
Topic starter
answered:
RE: Prusa - LCD character jibberish?
Ran my calibration a few times more with the USB connection to my pi disconnected and ran without issue. 👍
MK3s / My IKEA Lack enclosure
Publié : 05/05/2019 1:27 am