Notifications
Clear all

Problem with extruder HELP  

  RSS
wolf3x
(@wolf3x)
New Member
Problem with extruder HELP

I have this problem with my Prusa MK3s, i tryed everything. I am using good quality PLA. I tried loosen/thighten the extruder screw... The nozzle is brand new.

 

Opublikowany : 27/04/2020 2:44 am
wolf3x
(@wolf3x)
New Member
Topic starter answered:
RE: Problem with extruder HELP

Just found this thread, very similar, if anybody know what to do?

And yes, the filament is larger when i pull it form extruder... it happens every 3-4hrs, and sometimes its perfect from start till the end.

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/clicking-and-under-extrusion-no-clog/

 

This post was modified 4 years temu by wolf3x
Opublikowany : 27/04/2020 2:53 am
bobstro
(@bobstro)
Illustrious Member
RE: Problem with extruder HELP

Do some cold pulls. Your nozzle may have a partial clog.

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Opublikowany : 27/04/2020 5:14 am
Share: