Notifiche
Cancella tutti
Problem after firmware reset
After a month of printing without problems, I had to reset the firmware 3.8.1 because my mk3s only printed several seconds and than stoped without errors.
After reset, I was able to print the batman logo.
Than I tried to print an own part where the print job crashed at 80% two times. I tried to do a first layer calibration to do some adjustments but all results were bad.
Postato : 14/03/2020 10:09 am
RE: Problem after firmware reset
What happened after 80%? Did the print come out of bed or did the printer just stop?
Can you attach a picture of what your first layer looks like.
Bear MK3 with Bondtech extruder
Postato : 14/03/2020 10:30 am