Notifications
Clear all
Printer goes to centre of bed after every layer
Hi just joined and trying to look for a solution. I have a Prusa MK3S and what I have found is when I am printing anything, as soon as any layer is done, the X and Y goes to the centre of the bed then back to where the layer finished and moves up to continue. This is especially annoying in vase mode. I have the same problem in simplify 3d and prusaslicer. Any ideas??
Posted : 25/08/2019 6:35 am
mc_ott liked
RE: Printer goes to centre of bed after every layer
are you using octoprint with the timelapse plugin?
Posted : 25/08/2019 11:02 am
Topic starter
answered:
RE: Printer goes to centre of bed after every layer
I fixed it, I had the octolapse plugin and it was doing it, I just deleted it and went back to the default timelapse in octoprint and that fixed it
Posted : 25/08/2019 11:04 am
mc_ott liked