Printed this part multiple times. Woke to something very wrong this time.
 
Notifications
Clear all

Printed this part multiple times. Woke to something very wrong this time.  

  RSS
Gabriel Campbell
(@gabriel-campbell)
New Member
Printed this part multiple times. Woke to something very wrong this time.

Problem What even!? I have no idea how to fix this.

Napsal : 05/10/2022 2:28 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Printed this part multiple times. Woke to something very wrong this time.

I have no idea how to fix this.

here you will find information on how to remove the blob: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/recommendations-for-removing-a-massive-filament-blob-from-hotend/

good luck 👍 

wbr,

Karl

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Napsal : 05/10/2022 3:24 pm
Robin
(@robin)
Prominent Member
RE: Printed this part multiple times. Woke to something very wrong this time.

Wow, that's an impressive blob! You should post that to the hall of shame: https://forum.prusa3d.com/forum/english-forum-awesome-prints-hall-of-fame/hall-of-shame/

Good luck cleaning that up. *Fingers crossed*

If at first you don't succeed, skydiving is not for you.

Napsal : 05/10/2022 3:28 pm
towlerg
(@towlerg)
Noble Member
RE:

Sorry to be negative but if you order a spare theristor and heater cartridge now, you'll deblob without needing the spares. The umbrella theory.

This post was modified před 1 year by towlerg
Napsal : 06/10/2022 11:31 am
Robin se líbí
Share: