Powder coated sheets
I recently bought the powder coated but when i print pla on it, the corners warp. I tried using soap and water, isopropyl alcohol, and increasing the bed temp. Anyone know what else i could try.
RE: Powder coated sheets
Run a Live Z calibration and post a picture of your result here.
RE: Powder coated sheets
@robert-rmm200
Is this what you mean?
RE: Powder coated sheets
Show an image of the little rectangle it prints.
--------------------
Chuck H
3D Printer Review Blog
RE: Powder coated sheets
The calibration square (or circle) actually tells us a lot about the condition of your printer, in addition to verifying you have Z set correctly.
RE: Powder coated sheets
That actually - looks surprisingly good. Good adhesion between rows - does not look like Z is too low or too high. Not smeared into the plate.
At least to me.
What filament is that?
RE: Powder coated sheets
@robert-rmm200
Just some random pla. It only lifts up on large prints.
RE: Powder coated sheets
Might go down about 25-30 and wee what it does.
--------------------
Chuck H
3D Printer Review Blog
RE: Powder coated sheets
@charles-h13
I lowered the printing temp and it just stopped mid print.
RE: Powder coated sheets
He meant on Z - not on temp. Your filament solidified in the nozzle..
I think...
RE: Powder coated sheets
I am so sorry. I typed that on my phone and my reading glasses are at home. Lower your live Z 25-30 and try again.
--------------------
Chuck H
3D Printer Review Blog