Notifiche
Cancella tutti

Mk3 Z calibration Error  

  RSS
adrian.m11
(@adrian-m11)
New Member
Mk3 Z calibration Error

I have recently had to change the heat sink due to a clog i couldn't clear., However once i had reassembled everything and started the calibration the z axis goes all the way to the top churns a bit and then errors with a message saying the end stops have been reached.
I am not sure what i have done to cause this can anyone assist with diagnosis please?

Postato : 23/07/2018 8:24 am
Condividi: