machine just quit

Dernier message

RSS

james.b40

(@james-b40)

New Member

machine just quit

I finally got my mk2s up and running after replacing the faulty PSU. got through the calibration until doing the live Z adjustment. Going through the calibration the 2nd time, the machine just died, like someone pulled the plug. I cannot get it to start again, any suggestions would be appreciated thanks.

Jim

Publié : 13/04/2018 5:47 pm

john.n13

(@john-n13)

Estimable Member

Re: machine just quit

Fuse blown?

Publié : 13/04/2018 6:11 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.1 K Messages

23 En-ligne

68.1 K Membres

Le dernier des messages: M112 error when sending gcode from Octoprint to MK3.5S but prints fine from USB stick Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé