machine just quit

Dernier message

RSS

james.b40

(@james-b40)

New Member

machine just quit

I finally got my mk2s up and running after replacing the faulty PSU. got through the calibration until doing the live Z adjustment. Going through the calibration the 2nd time, the machine just died, like someone pulled the plug. I cannot get it to start again, any suggestions would be appreciated thanks.

Jim

Publié : 13/04/2018 11:28 pm

john.n13

(@john-n13)

Estimable Member

Re: machine just quit

I already replied to an identical post of yours from a few hours ago. Why are you posting the same wording again?

Publié : 13/04/2018 11:33 pm

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

20 En-ligne

68 K Membres

Le dernier des messages: Black Friday or should we say price adjustment for the upgrades for older printers Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé