Notifications
Clear all
Looking for the Heated bed screws for the MK3
Hello everyone, i'm trying to change my LM8UU bearings on my Y-axis, but i apparently was a little bit heavy handed when assembling the printer many years ago and stripped one of the hex heads on the machine screw, so i'm looking to get maybe 12 replacements to hopefully future proof stripping them again.
The ones i'm looking for are the ones circled in yellow in this picture. 
Thanks for any help!
Napsal : 19/01/2023 4:50 pm
RE: Looking for the Heated bed screws for the MK3
these are stainless m3 countersunk screws length 12mm or 14mm
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Napsal : 19/01/2023 6:05 pm
Topic starter
answered:
RE: Looking for the Heated bed screws for the MK3
Thanks! I'll check this out tomorrow.
Napsal : 20/01/2023 5:00 am