Notifiche
Cancella tutti
Looking for help to test 2 "tungsten carbide" nozzles 0 Poland/Lodz
Hello!
I got 2 "tungsten carbide" nozzles from Oston Carbide (China) and:
- is very sticky with PETG - bit of filament always stick to tip and cause failure on first layer, ALWAYS
- does not fit hotend thread
My printer is stock MK3S+
I am looking for someone (Poland/Lodz) willing to help checking if i just don't know how to setup printer with these nozzles.
Or at least check if they ARE actually tungsten carbide nozzles so i can issue money back for purchase.
Regards!
Postato : 16/02/2024 4:37 pm