Notifiche
Cancella tutti
Location of filament sensor info in firmware
I am upgrading my MK3 to a Bondtech BFG-M extruder and a Mosquito magnum hotend. Since there are no adapters currently for this setup I am having to create one. I am having to move the filament sensor from the right side of the filament to the left side of the filament and upside down. My question is where is the info for the MK3 filament sensor located in the firmware and does it matter if the sensor is upside down or not with the current firmware?
Jim
Questa discussione è stata modificata 5 years fa da gorillamotors
Postato : 28/05/2019 3:30 pm