Notifications
Clear all
Keep getting Error: MINTEMP BED FIXED
Printing on the Prusa MK3. I keep getting the MINTEMP BED FIXED error on my prints about 10 minutes in . I have tried printing with no heat on the bed, and am getting the same problem. Have reset the printer multiple times. Wiggling the wires doesn't seem to cause the error, so I am not sure what is going on. Thank you
Napsal : 05/08/2020 2:34 am
Topic starter
answered:
RE: Keep getting Error: MINTEMP BED FIXED
Fixed by splicing the thermistor wire back together
Napsal : 05/08/2020 10:46 pm