Just upgrade to MMU 2.0 and Self Test X Axis Fails
The X Axis moves the full length and then tells me there is an error on the X axis.
Belts are Tight and it looks like it moves the entire width of the printer.
Upgraded to Firmware 3.4 as well for the MMU.
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
Well, I shut it off, ate dinner, came back and now it's decided to cooperate....
It now passes calibration.
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
guess it was hungry. 😀
I have a Prusa,therefore I research.
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
Well, I shut it off, ate dinner, came back and now it's decided to cooperate....
It now passes calibration.
You showed it who is the boss. It was an alpha battle and you won. It will cooperate now, though expect it to test you now and again for leadership.
The key to 3D Printers is that you can NEVER show it weakness. Always let it know you are in charge else it could turn a great experience into a nightmare. 🙂
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
Well, I shut it off, ate dinner, came back and now it's decided to cooperate....
It now passes calibration.
You showed it who is the boss. It was an alpha battle and you won. It will cooperate now, though expect it to test you now and again for leadership.
The key to 3D Printers is that you can NEVER show it weakness. Always let it know you are in charge else it could turn a great experience into a nightmare. 🙂
Approaching the printer with a large wrench or hammer in hand and a grim expression can establish proper attitude but be sure to reward good performance once in a while 😀 :geek:
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
Oh yes establish dominance. Show it who is in charge. While checking on it every so often, giving it as close to a climate controlled environment as possible, feeding it only the best filaments, endless hours tweaking and showering love and attention on it.
Trust me. The freaking printer KNOWS who is in charge!
Just sayin',
Neal
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
Oh yes establish dominance. Show it who is in charge. While checking on it every so often, giving it as close to a climate controlled environment as possible, feeding it only the best filaments, endless hours tweaking and showering love and attention on it.
Trust me. The freaking printer KNOWS who is in charge!
Just sayin',
Neal
Re: Just upgrade to MMU 2.0 and Self Test X Axis Fails
every time you print....be the sandwich.... I need to print that
I have a Prusa,therefore I research.